Riverstone Networks RS 8000 Manual del operador descargar pdf (Pagina 111)

Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide 4-3

Initial Configuration Powering on the RS 8000/8600

Note

If the message “

SYS-E-NOFLASHCARD

” appears while booting the RS, the system

has not detected a PC card. If this occurs, ensure that the PC card is properly

inserted, then reboot. If the system still does not recognize the card, contact

Riverstone Networks, Inc. technical support.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 157 158

RS 8000/8600 1
Switch Router 1
Getting Started Guide 1
COPYRIGHT NOTICES 2
RADIACIÓN LÁSER Y CONECTORES 6
RIVERSTONE NETWORKS, INC 9
AGREEMENT 9
RIVERSTONE STANDARD WARRANTY 11
TABLE OF CONTENTS 15
LIST OF FIGURES 19
LIST OF TABLES 21
1 ABOUT THIS GUIDE 23
2 INTRODUCTION 25
2.2 SPECIFICATIONS 26
Introduction Specifications 27
2.3 SOFTWARE OVERVIEW 28
IP Routing 29
IP Multicast Routing 29
IPX Routing 29
2.3.9 Web Hosting Features 32
2.3.10 Management Platforms 32
2.4 HARDWARE OVERVIEW 33
Switching Fabric 34
Power supply 34
2.4.2 Backplane 35
2.4.3 Fan Module 35
2.4.4 Control Module 35
Boot Flash 36
Memory Module 36
100-125~5A 38
200-240~3A 38
50-60 Hz 38
100-125V~ 10A 39
200-240V~ 6A 39
50/60 Hz 39
2.4.6 DC Power Supply 40
10/100BASE-TXG8M-HTXA2-08 42
87654321 44
10/100BASE-TXG8M-HTXB2-16 45
100BASE-FXG8M-HFXA1-08 47
100Base-FX SFP Line Card 48
1000Base-SX Line Card 49
1000BASE-SXG8M-GSXB1-02 50
1000Base-LX Line Card 52
1000Base-LLX Line Card 54
1000Base-T Line Card 55
Multi-Mode Short-Reach 58
Single-Mode 58
Long-Reach (70 Km) 58
ATM Multi-Rate Line Card 63
ATM OC-12c Line Card 64
ATM-OC-12c-SMFG8M-A12B9-02 65
POS OC-3 MMFG8M-PO3B1-04 66
POS OC-3 SMFG8M-PO3B9-04 66
POS OC-12c SMFG8M-P12B9-02 68
G8M-PO3MM-02 69
POS MPLS OC3 69
G8M-P12MM-02 70
POS MPLS OC-12c/STM-4 70
Quad Serial - CEG8M-SECAC-04 71
Dual HSSI 73
G8M-HSIAC-02 73
CMTS Line Card 75
DOCSIS CMTSG8M-CMTSNA-6X1 76
Multi-Rate WAN Line Card 77
Channelized T3 Line Card 80
CHANNELIZED T3G8M-CT3BB-02 81
18-695-01 82
Figure 2-44 SRP bridge module 83
3 HARDWARE INSTALLATION 87
3.3 INSTALLING THE HARDWARE 88
3.2 HARDWARE SPECIFICATIONS 88
Internal Power Supply One 94
Internal Power Supply Two 94
RS 8600 DC Power Supply 94
Card Guides 96
Circuit Board 96
Metal Plate 96
To remove 100
Make sure WIC is aligned 104
Insert the WIC through the 104
(Base Slot) 105
G8M-SRP-MATE 106
Insert SFP into ports 107
4 INITIAL CONFIGURATION 109
If the message “ 111
4.2.1 CLI Access Modes 112
CONFIGURATION FILE 114
4.5 SETTING UP PASSWORDS 120
Here is an example: 122
4.6 SETTING UP SNMP 123
4.6.2 Improving SNMP Security 124
4.6.3 Supported MIBs 125
KRVWQD PH RU,3DGGU! 129
IDFLOLW\W\SH! 129
4.9.1 Fail Over 131
Software/Hardware Versions 134
Changing Mastership 134
Hot-Swapping 134
5 MANAGING SOFTWARE 135
Reboot the RS 139
Enter the 139
5.4 HITLESS SOFTWARE UPGRADE 143
5.4.1 Hitless Upgrade Example 144
5.5 UPGRADING FPGA CODE 146
APPENDIX A TROUBLESHOOTING 149
INFORMATION 151
Numerics 153

Comentarios a estos manuales

Sin comentarios

Riverstone Networks RS 8000 Manual del operador Pagina 111

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Riverstone Networks RS 8000