Riverstone Networks RS 8000 Manual del operador Pagina 141
- Pagina / 158
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Riverstone Networks RS 8000/8600 Switch Router Getting Started Guide 5-7
Managing Software Loading Software from the Network
Here is an example:
6.
Enter the
set
command to view the changes.
Here is an example:
7.
From the Boot prompt, use the
ping
command to verify that the RS can reach the TFTP server.
8.
Reboot the RS. As the RS initializes, it ignores the software image on the PC card and retrieves its
operating software from the TFTP server at
134.152.176.5
.
Here is an example:
rs-boot> set netaddr <IPaddr>
rs-boot> set netmask <subnet-mask>
rs-boot> set gateway <IPaddr>
rs-boot> set bootsource <dir-filename>
rs-root> set bootaddr <IPaddr>
rs-boot> set netaddr 134.152.179.132
rs-boot> set netmask 255.255.255.224
rs-boot> set gateway 134.152.179.129
rs-boot> set bootsource /tftpboot/ros80
rs-boot> set bootaddr 134.152.176.5
rs-boot> set
...
netaddr = 134.152.179.132
autoboot = boot
netmask = 255.255.255.224
gateway = 134.152.179.129
bootsource = /tftpboot/ros80
bootaddr = 134.152.176.5
ethaddr = 00:00:1d:12:34:56
(ethaddr is base MAC addr, add one for actual CPU MAC address)
sysid = -1
rs-boot>
rs-boot> boot
Rebooting. . .
. . .source: tftp://134.152.176.5/tftpboot/ros80
Build location: host 'matrix' by 'adm'...
Version: 8.0.0.0 . . .
- RS 8000/8600 1
- Switch Router 1
- Getting Started Guide 1
- COPYRIGHT NOTICES 2
- RADIACIÓN LÁSER Y CONECTORES 6
- RIVERSTONE NETWORKS, INC 9
- AGREEMENT 9
- RIVERSTONE STANDARD WARRANTY 11
- TABLE OF CONTENTS 15
- LIST OF FIGURES 19
- LIST OF TABLES 21
- 1 ABOUT THIS GUIDE 23
- 2 INTRODUCTION 25
- 2.2 SPECIFICATIONS 26
- Introduction Specifications 27
- 2.3 SOFTWARE OVERVIEW 28
- IP Routing 29
- IP Multicast Routing 29
- IPX Routing 29
- 2.3.9 Web Hosting Features 32
- 2.3.10 Management Platforms 32
- 2.4 HARDWARE OVERVIEW 33
- Switching Fabric 34
- Power supply 34
- 2.4.2 Backplane 35
- 2.4.3 Fan Module 35
- 2.4.4 Control Module 35
- Boot Flash 36
- Memory Module 36
- 100-125~5A 38
- 200-240~3A 38
- 50-60 Hz 38
- 100-125V~ 10A 39
- 200-240V~ 6A 39
- 50/60 Hz 39
- 2.4.6 DC Power Supply 40
- 10/100BASE-TXG8M-HTXA2-08 42
- 87654321 44
- 10/100BASE-TXG8M-HTXB2-16 45
- 100BASE-FXG8M-HFXA1-08 47
- 100Base-FX SFP Line Card 48
- 1000Base-SX Line Card 49
- 1000BASE-SXG8M-GSXB1-02 50
- 1000Base-LX Line Card 52
- 1000Base-LLX Line Card 54
- 1000Base-T Line Card 55
- Multi-Mode Short-Reach 58
- Single-Mode 58
- Long-Reach (70 Km) 58
- ATM Multi-Rate Line Card 63
- ATM OC-12c Line Card 64
- ATM-OC-12c-SMFG8M-A12B9-02 65
- POS OC-3 MMFG8M-PO3B1-04 66
- POS OC-3 SMFG8M-PO3B9-04 66
- POS OC-12c SMFG8M-P12B9-02 68
- G8M-PO3MM-02 69
- POS MPLS OC3 69
- G8M-P12MM-02 70
- POS MPLS OC-12c/STM-4 70
- Quad Serial - CEG8M-SECAC-04 71
- Dual HSSI 73
- G8M-HSIAC-02 73
- CMTS Line Card 75
- DOCSIS CMTSG8M-CMTSNA-6X1 76
- Multi-Rate WAN Line Card 77
- Channelized T3 Line Card 80
- CHANNELIZED T3G8M-CT3BB-02 81
- 18-695-01 82
- Figure 2-44 SRP bridge module 83
- 3 HARDWARE INSTALLATION 87
- 3.3 INSTALLING THE HARDWARE 88
- 3.2 HARDWARE SPECIFICATIONS 88
- Internal Power Supply One 94
- Internal Power Supply Two 94
- RS 8600 DC Power Supply 94
- Card Guides 96
- Circuit Board 96
- Metal Plate 96
- To remove 100
- Make sure WIC is aligned 104
- Insert the WIC through the 104
- (Base Slot) 105
- G8M-SRP-MATE 106
- Insert SFP into ports 107
- 4 INITIAL CONFIGURATION 109
- If the message “ 111
- 4.2.1 CLI Access Modes 112
- CONFIGURATION FILE 114
- 4.5 SETTING UP PASSWORDS 120
- Here is an example: 122
- 4.6 SETTING UP SNMP 123
- 4.6.2 Improving SNMP Security 124
- 4.6.3 Supported MIBs 125
- KRVWQD PH RU,3DGGU! 129
- IDFLOLW\W\SH! 129
- 4.9.1 Fail Over 131
- Software/Hardware Versions 134
- Changing Mastership 134
- Hot-Swapping 134
- 5 MANAGING SOFTWARE 135
- Reboot the RS 139
- Enter the 139
- 5.4 HITLESS SOFTWARE UPGRADE 143
- 5.4.1 Hitless Upgrade Example 144
- 5.5 UPGRADING FPGA CODE 146
- APPENDIX A TROUBLESHOOTING 149
- INFORMATION 151
- Numerics 153
Relacionado con productos y manuales para Redes Riverstone Networks RS 8000
Redes Riverstone Networks WICT1-12 Especificaciones
(111 paginas)
(111 paginas)
Redes Riverstone Networks RS 8000 Manual de usuario
(23 paginas)
(23 paginas)
Redes Riverstone Networks RS 8000 Guía de usuario
(718 paginas)
(718 paginas)
Redes Riverstone Networks RS 2100 Especificaciones
(120 paginas)
(120 paginas)
Redes Riverstone Networks WICT1-12 Especificaciones
(77 paginas)
(77 paginas)
Redes Riverstone Networks RS 2100 Manual de usuario
(16 paginas)
(16 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.075 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales