Riverstone Networks WICT1-12 Especificaciones descargar pdf (Pagina 57)

Riverstone Networks RS 32000 Switch Router Getting Started Guide 3-7

Hardware Installation Installing the Hardware

Figure 3-3 Installing a DC power supply

5. Attach wires to the terminals on the front of the unit. To attach a wire, remove the terminal nut, place

the cable’s wiring lug over the terminal stud, replace and tighten the terminal nut.

6. Connect the safety ground wire to a reliable earth ground.

7. Connect the DC input wiring to the DC power source.

Note If power to the DC power supply is connected incorrectly (reversed), the power

supply emits an audible alarm.

DC Power Supply

slides into chassis between

alternate guide rails and

straddles center guide rail

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 110 111

RS 32000 Switch Router 1
Getting Started Guide 1
COPYRIGHT NOTICES 2
RIVERSTONE NETWORKS, INC 8
AGREEMENT 8
RIVERSTONE STANDARD WARRANTY 10
TABLE OF CONTENTS 13
LIST OF FIGURES 15
LIST OF TABLES 17
1 ABOUT THIS GUIDE 19
2 INTRODUCTION 21
2.2 SYSTEM OVERVIEW 22
2.3 SOFTWARE OVERVIEW 23
IP Routing 24
IP Multicast Routing 24
IPX Routing 25
2.3.8 Web Hosting Features 27
2.3.9 Management Platforms 27
2.4 HARDWARE OVERVIEW 28
Control Modules 29
2.4.2 Backplane 30
2.4.3 Fan Assembly 30
2.4.4 Switch Fabric Module 31
2.4.5 AC Power Supply 32
2.4.6 DC Power Supply 33
2.4.7 Control Module 34
Boot Flash 35
Memory Module 35
Control Module LEDs 36
RJ-45 Connectors 38
87654321 39
Multi-Mode Short-Reach 46
Single-Mode 46
Long-Reach (70 Km) 46
Status Indicators 48
3 HARDWARE INSTALLATION 51
3.2 HARDWARE SPECIFICATIONS 52
3.3 INSTALLING THE HARDWARE 53
Rackmount Shelf 54
Into Rack 54
AC Power Supply 55
DC Power Supply 57
Switch Fabric Door 59
Rotates Up to 59
Open Position 59
Rotate ejector 61
3.3.7 Installing Line Cards 64
4 INITIAL CONFIGURATION 67
4.2.1 CLI Access Modes 70
CONFIGURATION FILE 72
• System time and date 75
• System name 75
• System location 75
4.5 SETTING UP PASSWORDS 78
Here is an example: 80
4.6 SETTING UP SNMP 81
4.6.2 Improving SNMP Security 82
Table 4-4 Supported MIBs 83
<hostname-or-IP-addr> 87
4.9.1 Fail Over 89
Software/Hardware Versions 92
Changing Mastership 92
Hot-Swapping 92
5 MANAGING SOFTWARE 93
Reboot the RS 32000 97
5.4 HITLESS SOFTWARE UPGRADE 101
• The backup CM is rebooted 102
5.4.1 Hitless Upgrade Example 102
APPENDIX A TROUBLESHOOTING 105

Comentarios a estos manuales

Sin comentarios

Riverstone Networks WICT1-12 Especificaciones Pagina 57

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Riverstone Networks WICT1-12