Riverstone Networks WICT1-12 Especificaciones descargar pdf (Pagina 95)

Riverstone Networks RS 32000 Switch Router Getting Started Guide 5-3

Managing Software Upgrading Boot PROM Software

Note If the RS has a redundant Control Module, the upgrade performed on the primary

CM will occur automatically on the backup CM.

6. Use the system image list command to verify the change.

Note You do not need to activate this change.

7. Reboot the RS 32000 to load and run the new system software image.

5.2 UPGRADING BOOT PROM SOFTWARE

The RS 32000 boots using the boot PROM image software installed on the Control Module’s internal memory. To

upgrade the boot PROM image, use the following procedure.

1. Display the current boot settings by entering the system show version command. Note the

current

Boot Prom Image version.

Here is an example:

2. Copy the upgrade boot PROM image software onto a TFTP server that the RS 32000 can access.

(Use the

ping command to verify that the RS 32000 can reach the TFTP server.)

Note If the TFTP server is one or more hops away from the RS 32000, add a route to

the TFTP server’s network using the ip add route command.

3. Enter the following command to copy the bootPROM upgrade onto the RS 32000’s internal

memory:

rs# system show version

Software Information

Software Version : 8.0

Image Information : ros8000, built on Mon Jan 25 14:10:21 2000

Image Boot Location: file:/pc-flash/boot/img/ros8000

Boot Prom Version : prom-2.0.0.5

system promimage upgrade <IPaddr-of-TFTP-host> <image-file-name>

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 110 111

Sin comentarios

Riverstone Networks WICT1-12 Especificaciones Pagina 95