Riverstone Networks WICT1-12 Especificaciones descargar pdf (Pagina 76)

4-10 Riverstone Networks RS 32000 Switch Router Getting Started Guide

Setting the Basic System Information Initial Configuration

Here is an example:

5. Use the interface add ip command to set the IP address and netmask for the en0 Ethernet

interface. The en0 Ethernet interface is used by the management port on the Control Module.

Here is an example:

Note The en0 interface is automatically created by the system and is reserved for the

management port on the Control Module.

6. To activate the system commands entered in the previous steps, use the following command:

The CLI displays the following message:

7. Enter “y” to activate the changes.

8. To display the Active configuration, exit the Configuration mode, then enter the following

command:

Here is an example:

rs(config)# system set name rs

rs(config)#

system set location "Houston, TX"

rs(config)# system set contact "John Smith"

rs(config)# interface add ip en0 address-netmask 16.50.11.22/16

save active

Do you want to make the changes Active? [y]

system show active-config

rs# system show active-config

Running system configuration:

! Last modified from Console on Mon Jan 25 11:55:35 2001

1 : system set name "rs"

2 : system set location "Houston, TX"

3 : system set contact "John Smith"

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 110 111

Sin comentarios

Riverstone Networks WICT1-12 Especificaciones Pagina 76